Startup Sequence; Options; Hard Drive Installation - Intermec 5055 User Manual

SECTION 2 Operation
"

Startup Sequence

Your computer should start up after all connections have
been made to the unit, power has been applied, and the On/
Off switch has been moved to the ON position (press the 1
side of the switch). During startup, the computer (1) per-
forms a power-on self-test, (2) runs the hardware initializa-
tion program, and (3) boots the operating system.
Once the computer starts up ("boots") successfully, you may
load additional application software if this has not already
been done for you. If you install a radio or other optional
device, you may have to install driver software or make new
system setups for the device(s) to work properly.

Options

This computer can accomodate a 2.5 inch hard drive (or a
SanDisk drive) plus two PC cards. The instructions and
illustrations that follow will help you perform these instal-
lations if they have not already been done.

Hard Drive Installation

An adapter is required to install a spinning media hard
drive. Refer to the accompanying illustrations and the fol-
lowing instructions to attach the adapter to your drive.
1. Install the jumper exactly as shown.
2. Place the drive in the adapter as shown.
3. Align the connector-end of the drive and the adapter.
4. Use four screws to secure the drive.
5. Slide this assembly gently into the computer (Figure
2-2 5055 Data Collection PC User's Guide
2-4) until the latch snaps into place.