Pc Card Installation - Intermec 5055 User Manual

SECTION 2 Operation
"

PC Card Installation

The hard drive bay and PC Card drives ("slots") are located
on the bottom of the computer. Use a Phillips screwdriver
to remove the antenna connector panel to access the drive
bays. If your PC card is a radio module, follow these in-
structions to install the module (PC card) itself, then see
Radio Installation (following Figure 2-4) to complete the
procedure.
" NOTE:
Follow these same instructions to install a hard drive (with adapter
attached). See Figure 2-4 for the hard drive bay location. Disregard
steps 3 and 4 below when installing a hard drive.
To install a PC Card, follow these steps:
B CAUTION:
Take care to remove ONLY those screws that retain the cover.
1. Remove the antenna connector panel.
2. Hold the PC Card (or hard drive) with the connector
B CAUTION:
Do NOT force PC cards or drives into their slots.
3. Slide the PC Card into either slot.
4. If you encounter excess resistance, you may need to
5. Use Program Manager to check the Card View icon. It
B CAUTION:
Reinstall the antenna connector panel to maintain unit integrity.
6. Reinstall the drive bay cover.
2-6 5055 Data Collection PC User's Guide
facing into the computer.
flip the card over and repeat Step 3. The card is fully
seated when the card ejector is extended.
will identify which slot contains a PC Card and which
slot is empty. PC Cards are identified as drive D:\
and E:\.