SECTION 2
Operation
"
SanDisk Drive Installation
An adapter is also required to install a SanDisk drive. Re-
fer to accompanying illustrations and the instructions below
to attach the adapter to your drive. If your computer is set
up so that C: = Removable, this means the SanDisk drive
will be the boot disk and does not require a jumper. If your
computer will boot from some other source, the SanDisk
drive must be jumpered.
1. IF the SanDisk is not the boot drive, install the jumper
2. Place the SanDisk drive in the adapter as shown.
3. Align the connector-end of the drive and the adapter.
4. Use four screws to secure the drive.
5. Slide this assembly gently into the computer (Figure
1
2-4
5055 Data Collection PC User's Guide
exactly as shown.
2-4) until the latch snaps in place.
1. Bootable (no jumper)
2. NOT bootable (jumper in place)
Figure 2-2
SanDisk Jumper
2