Rear Panel 1 - Panasonic AK-UCU600P Operating Instructions Manual

Rear panel 1

10 3 4
1 [UHD/HS/HD SDI OUT]
connectors [1] to [4]
2 [HD SDI OUT] connectors [5] to
[7] and [8/PM]
3 [VBS OUT] and [VBS PM OUT]
connectors
4 [VBS RET IN] connector
5 [HD SDI PROMPT IN] and [HD
SDI PROMPT OUT] connectors
6 [HD TRUNK/TICO OUT]
connector
7 [RET1 IN] to [RET4 IN] and
[RET1 OUT] connectors
8 [ANALOG PROMPT1 IN] and
[ANALOG PROMPT2 IN/OUT]
connectors
5 6 1 8
7 2
UHD (connects to the AK-UC4000), HS and 3G-HD, HD video signal output connectors (BNC).
Signals output can be selected from the CCU menu.
"OUT FORMAT(UHD)" (see page 53)
"OUT FORMAT(HD)" (see page 55)
"OUT FORMAT(UHD_HDR)" (see page 57)
"OUT FORMAT(HD_HDR)" (see page 59)
These connectors (BNC) are for outputting SDI signals in HDTV format. The 3G-HD/HD output
mode can be selected by setting the CCU menu.
SDI output from the [8/PM] connector can be switched to main line image output or picture
monitor output via the CCU menu configurations or ROP control.
"OUT FORMAT(UHD)" (see page 53)
"OUT FORMAT(HD)" (see page 55)
"OUT FORMAT(UHD_HDR)" (see page 57)
"OUT FORMAT(HD_HDR)" (see page 59)
This connector (BNC) is for outputting analog composite signals in SDTV format.
The output from [VBS PM OUT] connector can be switched between output for this unit and
output for the picture monitor via the CCU menu configurations.
"SETTING(1/2)" (see page 60)
This unit's analog composite signal is for use with a monitor. Frame sequence locking is not
applied to the BB (black burst) synchronization signal.
This connector (BNC) is for inputting analog composite signals for return images in SDTV
format.
These connectors (BNC) are for inputting HD-SDI prompter signals.
An active through signal is output from the [HD SDI PROMPT OUT] connector.
This connector outputs the HD SDI TRUNK signal input or TICO to the camera.
These connectors (BNC) are for inputting SDI signals for return images in HDTV and SDTV
formats.
3G, HD-SDI, and SD-SDI signals are detected automatically.
The signal input to [RET1 IN] connector is output from the [RET1 OUT] connector as an active
through signal.
This connector (BNC) is for inputting SD analog composite signals for the prompter.
It is not terminated when the unit is turned OFF.
You can switch between "output connector for the signal input to IN" or "input connector for
ANALOG PROMPT2" for the [ANALOG PROMPT2 IN/OUT] connector via menu configurations.
However, the signal is not output when the unit is turned OFF.
- 24 -
9
Parts and their functions