Panasonic AK-UCU600P Operating Instructions Manual page 78

Item Setting value
USER NONE
BUTTON1 CHARA
BARS
CLEAN
USER NONE
BUTTON2 CHARA
MENU/USER1
LOCK
BARS
CLEAN
ROP SW FRONT ONLY
REAR ONLY
SWITCH
SELECT
TALLY MAKE
V
PANEL LED 1 to 3 to 5
BRIGHT
7SEG BRIGHT 1 to 8 to 15
LAN TRUNK 1Gbps
100Mbps
Set the function to be assigned to the [USER1] button on the front panel.
NONE
No assignment
CHARA
Character display, operation
BARS
Color bar ON/OFF
CLEAN
PM/NORM selection for SDI8 OUT
Set the function to be assigned to the [USER2] button on the front panel.
NONE
No assignment
CHARA
Character display, operation
MENU/USER1 LOCK
Invalidate [MENU] button, [USER1] button
(Function is assigned, but nothing happens when button pressed.)
BARS
Color bar ON/OFF
CLEAN
PM/NORM selection for SDI8 OUT
Sets the connector used to connect ROP.
FRONT ONLY
Allows connection via the front panel only, regardless of the switch.
REAR ONLY
Allows connection via the rear panel only, regardless of the switch.
SWITCH SELECT
The setting will be determined by the front panel switch setting.
Select the input format for the TALLY signal.
MAKE
When the circuit between the TALLY IN H terminal and TALLY IN C terminal is OPEN, TALLY is
OFF, and when it is MAKE, TALLY is ON.
• The TALLY IN H terminal is internally pulled up to +5 V with a 2.2 K resistor through a
protective diode. The maximum current is 20 mA or less.
V
When voltage is applied to the TALLY IN H terminal, TALLY is ON, and when voltage is not
applied, TALLY is OFF. Connect TALLY IN C to GND.
• A resistor of about 12.4 kΩ is inserted between TALLY IN H and TALLY IN C. The maximum
voltage that can be applied is 24 V, and the maximum current is 20 mA.
Sets the brightness of the front panel indicators.
Sets the brightness of the 7-segment indicators.
Sets the communication speed for when LAN TRUNK is used.
- 78 -
Setting details
CCU menu