Connector Area; Rear Side - Panasonic AG-EC4G Operating Instructionsc

AG-EC4G(VQT2H46)_EGFISJ.book 10 ページ ２００９年１０月８日 木曜日 午後４時５分
Parts and their functions

Connector area

1
1. CAM/BS connector
This is used to connect the unit with the
camera recorder or base station.
Pin No.
1
1
8
2 7
2
9 10
3
6
3
4 5
4
5
6
7
8
9
10
2. VIDEO OUT connector
This is a connector to output the video
signal to be monitored. The video signal
output from the remote connector of the
camera recorder and the base station is
output directly.
<Notes>
The video signal output from this
connector is for monitoring. The
chromatic level of the video signal will
be decreased when the 50 meter
remote cable is used.
Since the video signal output from this
connector is analog a certain amount
of pulsing or noise may appear in the
picture if strong electric fields are
present.
(Continued)

Rear Side

2
Signal
CAM DATA (H)
CAM DATA (C)
CAM CONT (H)
1. Frequency charateristic
CAM CONT (C)
adjustment knob
ECU ON
This is used to adjust the frequency
characteristics of the video signal output
Video input
from the VIDEO OUT connector.
GND (Video)
Standby
2. Level adjustment knob
+12 V (IN)
This is used to adjust the level of the
GND
video signal output from the VIDEO OUT
connector.
<Note>
To make adjustments with the above-
described knobs, remove the rear side cover,
and insert a slotted screwdriver etc. with a
head width of around 2.5 mm.
CAM/BS VIDEO OUT
1
2
E-10