Table of Contents
Advertisement
Understanding the Signal Booster Lights and
Troubleshooting
During installation mode the Signal Booster is resetting itself very
quickly to aid the installer . The Signal Booster is equipped with
one indicator light for the 700 MHz band and one for the power .
For the first 15 minutes that the Signal Booster is plugged in, it is
programed for a test and alignment period .
Note: If after the initial 15 minutes you are not done with the
installation, the Signal Booster can be reset and enter installation
mode again by disconnecting and reconnecting the power supply
from the Signal Booster.
1. BLINkING GREEN
If the Signal Booster 700 MHz light is blinking green, the Signal
Booster is operating properly . If you are happy with the coverage
area in your building, then you are done . Blinking will stop after
the 15 minute installation period .
2. BLINkING ORANGE
If the 700 MHz light on the Signal Booster is blinking orange, the
Signal Booster is experiencing receiver (cell tower) overload .
The Signal Booster has protection shut off circuits to prevent
the disruption of cell towers . If the light is blinking orange, this
indicates that gain should be reduced due to close proximity to a
cell tower . First, turn down the uplink (UL) gain control until you
get a blinking green light . Do not adjust the downlink (DL) knob
at this time . The Signal Booster is now working with reduced gain
on the uplink . If the gain is not adequate for good coverage, you
will need to turn the UL gain to maximum and then rotate the
Outside Antenna until the light turns to blinking green, waiting
5 seconds between each adjustment for the Signal Booster to
13
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
For the first 15 minutes the
700 MHz light will do one of
the following 4 things:
Advertisement
Table of Contents
