Table of Contents
Advertisement
Understanding the Signal Booster Lights,
LCD Screen and Troubleshooting
During installation mode the Signal Booster is resetting itself very quickly
to aid the installer . The Signal Booster is equipped with two indicator lights
shown in Figure 8 on page 14 . For the first 15 minutes that the booster is
plugged in, it is programmed for a test and alignment period . During this
time, the light and the LCD will do one of the following 4 things:
Note: If after the initial 15 minutes you are not done with the
installation, the Signal Booster can be reset and enter installation
mode again by disconnecting and reconnecting the power supply
from the booster.
1. BLINkING GREEN
If the Signal Booster is blinking green, the Signal Booster is operating
properly . If you are happy with the coverage area in your building, then
you are done . Blinking will stop after the 15 minute installation period .
2. LCD SCREEN OvERLOAD
If the LCD screen displays
"OVERLOAD," (see Figure 6) the
Signal Booster has automatically
reduced gain to protect a nearby
cell tower . First turn the appropriate
gain control knob until the
"OVERLOAD" is replaced by the
normal LCD screen (see Figure
7) . The booster is now working
with reduced gain . If the gain is
not adequate for good coverage,
you will need to turn the gain
to maximum and then turn the
Outside Antenna away from the
cell tower until the "OVERLOAD"
is replaced by the normal LCD
screen . If the booster will not respond, turn the gain down 5 dB and
move the Outside Antenna position until the "OVERLOAD" is replaced
by the normal LCD screen .
13
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
Figure 6
OVERLOAD
62 AA' 72
Figure 7
800 MHz Channelized
Min
UL
Select
Gain
Max
800 MH
70 AA' 72
800 MHz Channelized
Min
UL
Gain
Select
Max
Mon.- Fri. Hours: 7 am to 6 pm MST.
Min
CH
DL
Gain
Max
Z
Min
CH
DL
Gain
Max
Advertisement
Table of Contents
