Main Oven Light; The Browning Element; Storage; Cleaning Your Cooker - Falcon Professional+ 110 Dual Fuel with FSD User Manual & Installation & Service Instructions

Main Oven Light

Press the button to turn the light on:
ArtNo.320-0026
- Oven light
If the oven light fails, turn off the power supply before you
change the bulb. See the 'Troubleshooting' section for details
on how to change the bulb.

The Browning Element

The Browning Element is positioned in the top of the left-
hand oven. It can be used at the end of a normal cooking
period to give extra browning to au gratin dishes or give a
crisper finish to meat.
After the normal cooking is finished turn the left-hand
oven thermostat knob clockwise to the browning position,
indicated by ( ) on the fascia panel.
Only the browning element will operate when the thermostat
is turned to this position. The top and base cooking elements
will automatically switch off.

Storage

The bottom drawer is for storing oven trays and other
cooking utensils. It can get very warm, don't store anything
in it that may melt or catch fire. The drawer can be removed
completely by pulling it right out and up.
ArtNo.340-0002 110 removing the drawer
ArtNo.340-0001 110 drawer position

Cleaning your Cooker

Essential Information
Isolate the electricity supply before carrying out any
thorough cleaning. Then allow the cooker to cool.
Never use paint solvents, washing soda, caustic cleaners,
biological powders, bleach, chlorine based bleach cleaners,
coarse abrasives or salt. Don't mix different cleaning products
– they may react together with hazardous results.
All parts of the cooker can be cleaned with hot soapy water
– but take care that no surplus water seeps into the appliance.
Remember to switch on the electricity supply and reset the
clock before re-using the cooker.
We have developed a range of cleaning products that give
maximum performance without damaging the enamel and
painted surfaces. More information is available through either
the Cookware Collection brochure supplied with your cooker or
our website www.rangemaster.co.uk.
Hotplate Burners
Some models have a separate trim ring, which fits on the
burner head.
The burner heads and caps can be removed for cleaning.
Make sure they are absolutely dry before replacing them.
The Single Ring Burners
When refitting the burner head, ensure that the notch lines
up with the electrode or hole in the base. Check that the
burner head is level and that the cap is fitted centrally on the
burner head:
�
�
�
ArtNo.311-0013 Burner layout
A - Cap, B - Head, C - Notch, D - Electrode, E - Base
11
�
�