NEC EXPRESS5800/180Ra-7 User Manual page 196

Table 5-3. POST Error Codes and Messages (continued)
Error Code and Message
0270 Real Time Clock
Error
0271 Check date and time
setting
02B0 Diskette drive A
error
02B2 Incorrect Drive A
type - run SETUP
0230 System RAM Failed
at offset:
0231 Shadow RAM Failed
at offset:
0232 Extended RAM
Failed at address
line:
02F8 Processor BIST
Error detected on
CPU #1
02F9 Processor BIST
Error detected on
CPU #2
02FA Processor BIST
Error detected on
CPU #3
02FB Processor BIST
Error detected on
CPU #4
02FC Processor BIST
Error detected on
CPU #5
02FD Processor BIST
Error detected on
CPU #6
02FE Processor BIST
Error detected on
CPU #7
02FF Processor BIST
Error detected on
CPU #8
5-30 Problem Solving
Description
Real-time lock error
Real-time clock is set incorrectly.
Floppy disk A error
The type of drive A is incorrect.
System RAM error
Shadow RAM error
Extended RAM error
CPU BIST error
Action
Replace the system I/O board. Contact your
service representative to replace the system
I/O board.
Start the SETUP utility and select [Main] →
[System Time] → [System Date] to set the
correct time. If the same error reoccurs,
contact your service representative to
replace the I/O riser board or system I/O
board.
Start the SETUP utility and select [Main] →
[Diskette A] to set the required value again.
Check if the floppy drive cable is correctly
connected. If the error persists, contact your
service representative to replace the I/O
riser board or floppy disk drive.
Start the SETUP utility to set required values
again. If the error persists, contact your
service representative to replace the I/O
riser board.
Contact your service representative to
replace the baseboard, memory board, or
DIMM board.
Contact your service representative to
replace the failed CPU (numbered).