Removing A 5 1/4-Inch Device - NEC EXPRESS5800/180Ra-7 User Manual

Figure 4-49. Installing the Device into the BSU Chassis
13. Install the BSU front bezel. See Installing/Removing the BSU Front Bezel
and Top Cover earlier in this chapter.
14. Plug in the power cords and power up the system.
15. Run the BIOS Setup to configure the device.

Removing a 5 1/4-Inch Device

Remove a 5 1/4-inch device as follows.
1. Perform steps 1 through 5 of the previous subsection Installing a 5 1/4-Inch
Device.
2. From the bay where you want to remove the device, remove the two screws
securing the device to the 5 1/4-inch device tray and pull the device halfway
out the tray. Then disconnect the power and data cables from the device, see
Figure 4-50
Figure 4-50. Disconnecting the Power and Data Cables
4-46 Upgrading Your System