Table of Contents
Advertisement
A
Figure 4-75. Preparing to Install the 2-Channel SCSI Board
13. Remove the two screws securing the blank plate covering the optional SCSI
connector cutout on the rear panel of the DEU (see Figure 4-76, A). Remove
the blank cover.
Figure 4-76. Removing the SCSI Blank Panel
14. Connect the internal SCSI cable to the cabinet. Position the cable's connector
inside the cabinet at the position from which the dummy cover was
removed. Ensure the connector is positioned in the same direction as the
internal SCSI cable already mounted. Secure the connector with the two
hex-nuts supplied. See Figure 4-77, A.
B
Disk Expansion Unit
A
Upgrading Your System 4-69
Advertisement
Table of Contents
Troubleshooting
