Master Code - Burkert 8750 Quick Start Manual

Description of the display
Graphical display of SP and PV
with time axis
Graphical display of POS and
CMD with time axis
Value overview
Pressure sensor P1 and P2
Time, weekday and date
Automatic adjustment of the
process controller
Automatic optimization of the
process controller parameters
18
set at the
Display
factory
–
MENU SP / PV (t)
–
MENU CMD / POS (t)
P1 bar
P2 bar
X
MENU P.LIN SP/PV MANU
CLOCK
12:00
–
Thu. 25 . 06 . 15
MENU X.TUNE
POS (t)
X.TUNE
–
MENU P.TUNE RUN
CLOCK
P.TUNE
–
MENU X.TUNE
english
Description of the display
Automatic linearization of the
process characteristics
HOLD
Simultaneous display of the nominal
position and the set-point position
of the valve actuator (0–100 %)
HOLD
Tab. 6: Display in the AUTOMATIC operating state
0.0
0.0
8.5 Master code
Operation of the device can be locked via a freely selectable user
00
code. In addition, there is a non-changeable master code with which
you can perform all operator control actions on the device. This
INPUT
4-digit master code can be found on the last pages of the printed
quickstart guide in the Chapter "Master code".
If required, cut out the code and keep it separate from this quickstart
guide.
P.LIN RUN
Typ 8750
Controlanddisplayelements
set at the
factory
P.LIN
–
MENU
CMD
POS
–
MENU P.LIN SP/PV MANU
Display
RUN
P.TUNE CMD/POS
0.0
0.0