Carefree Travel series Installation Manual page 8

A T '
DJUSTABLE RAVEL R WITH
7. Confirm that the arm is perpendicular to the awning rail,
attach the arm through the #1 mounting hole using a 5/32"
pilot hole and a 1/4 x 1-1/2" lag screw.
8. Position the roller assembly so that it is perpendicular to
the motorized arm assembly. Position the non-motorized
arm perpendicular to the roller assembly.
9. Drill a 5/32" hole through the #2 mounting hole and attach
the non-motorized arm using a 1/4 x 1 1/2" lag screw.
10. Check the alignment; the arm assembly must be
perpendicular to the roller assembly. When the alignment
is correct, drill and attach the arm through the #1 mounting
hole using a 5/32" drill bit and a 1/4 x 1-1/2" lag screw.
11. Hold the awning closed and carefully remove the plastic
wraps at the top of the arms. The awning will open a few
inches.
12. Open the awning about 18" or until the top mounting holes
on the arms are visible. To open:
12.1. Temporarily connect the ends of the motor wires
to a 12V-14V source (i.e. drill battery).
awning does not begin to move, reverse the
leads.
12.2. Remove the battery after the awning is open.
13. Drill 5/32" pilot holes for the upper mounting holes then
attach using 2 ea 1/4 x 1 1/2 lag screws.
14. Attach either the #3 or #4 lower mounting hole with a 1/4 x 1 1/2 lag screw or moly rivet.
6
DR Installation Manual
Upper Mounting Holes
(Arm Extended Out)
If the
Lower Mounting Holes
Carefree of Colorado
1/4 x 1 1/2 Screws
#4 Mounting Hole
For Lower Holes Use
1/4 x 1 1/2 Screws
or
3/16 Moly Rivets
#3 Mounting Hole
#2 Mounting Hole
#1 Mounting Hole
TravelR031a
052540-031r4