Direct Response Installation; Routing The Wire Into The Vehicle; Installing The Switches; Wiring An Additional Patio Switch - Carefree Travel series Installation Manual

Adjustable arms and canopy with direct response patio awning
Table of Contents

Advertisement

Carefree of Colorado
D
R
IRECT
ESPONSE
WARNING
working on or around the electrical system.
Notes:
1. Failure to follow the wiring instructions in this publication may void the motor warranty.
2. D
wire two or more motors to one switch—No parallel wiring.
O NOT
3. All wiring must conform to NEC (National Electrical Code) and local codes.

Routing the Wire into the Vehicle

1. Determine the final layout of the switches and the control box and mark
the locations.
2. Drill a 1/2" hole through the outside wall of the vehicle.
3. Route the sensor cable and motor wires through the hole and into the
vehicle.
Tip: Insert the sensor cable connector through the hole first then insert
the motor cable.
4. Seal the cables and holes using a silicone sealant.

Installing the Switches

1.
At the switch location cut a 3.5" [8.9cm] x 1.5"
[3.8cm] hole
2.
Push the wires and switches into the hole
then attach the switch frame using four (4) #6
x 1/2" screws.
NOTICE
are oriented with the ON/OFF switch on
the left to match the faceplate labels for
the switch identification and orientation.
Tip: Drilling a small pilot hole for the screws
will reduce the chance of splitting or stripping
out the holes in the mounting surface.
3.
Press the face plate onto the switch frame.

Wiring an Additional Patio Switch

(Refer to the wiring diagram on page 10)
1.
Route the switch wires to the main switch location.
2.
Splice the wires in parallel with the E
should go to pin 1 of the main patio switch etc.
052540-031r4
Installation Manual
I
NSTALLATION
Shock Hazard. Always disconnect battery or power source before
Ensure that the switches
XTEND
#6 x 1/2" Screw
(4 plcs)
2 . 9 "
[ 7 . 4 c
m ]
4 . 2 5 "
[ 1 0 . 8
c m ]
/R
switch wires. Pin 1 of the additional switch
ETRACT
Adjustable T
'
RAVEL
R WITH
Ø1/2"
Hole
Motor
Module
Cable
Cable
Top of Channel Routing
Ø1/2" Hole
Motor
Module
Cable
Cable
Bottom of Channel Routing
TravelR006b
3 . 5 "
[ 8 . 9 c
m ]
1"
[2.5cm]
Min. Clearance
DR
1 . 5 "
[ 3 . 8 c
m ]
DR040
7

Advertisement

Table of Contents
loading

Table of Contents