Carefree Travel series Installation Manual page 16

A T '
DJUSTABLE RAVEL R WITH
P C
OWER ONNECTION FOR OPTIONAL
The RGB LED uses a receiver and remote (SR0109).
NOTES:
a) The installation requires that the power line (+12VDC) be attached to a dedicated 2A circuit breaker
or a 2A in-line fuse must be installed between the control module and power source. Locate the
fuse for easy access. Fuse and connector are furnished by the installer.
b) Per RVIA Low Voltage Systems in Conversion and Recreation Vehicles Chapter 3, Section 3-1: For
Carefree LED strip lighting near the awning rail: when the 24AWG power harness is spliced or
connected 10" or less from the harness connector using a heavier gauge wire, the fuse size is
determined by the heavier wire gauge.
+12VDC
Red
18awg Wire
(minimum)
Vehicle Wall
LED Strip
Remote
Polarity Alignment:
Align Arrows
on Connectors
OFF ON
R G B W
FLASH
Infrared Sensor
STROBE
FADE
SMOOTH
1. Route the power cable into the vehicle with the motor cables from the awning.
2. Route the Red wire to +12Vdc.
3. Route the Black wire to ground.
4. Ensure that the connections are tight, solid and sealed when completed.
5. For awning rail applications:
5.1. Mount the control module and RF sensor on the outside of the vehicle as shown using double
sided tape.
5.2. Connect the module wires to the power harness and LED strip.
NOTE: The LED connector and receiver connectors must be oriented with the arrows on the
connectors lined up. The lights will not work if the connectors are not properly oriented.
14
DR Installation Manual
2A In-line Fuse
(+12VDC Line)
Power Harness
Receiver
Module
OEM RGB LED'
LED Strip
GND
at Awning Rail
Receiver
Attach to Side of Channel
with Double Sided Tape
IR Sensor
Attach to Vehicle Wall
with Double Sided Tape
Carefree of Colorado
S
Allow 3"-4" of
Harness to Extend
Past Top of Arm
Power Harness
Route into Vehicle
with Motor Wire
Awning Rail Mount
arLED005
052540-031r4