4 Programming Reference
Reset (*RST) and Interface Settings
Reset State settings are set when the unit is reset.
Parameter
Over-current protection:
Over-voltage protection:
Under-voltage protection:
Output resistance:
Open-circuit voltage:
Initial cell current:
Output inhibit mode:
Test duration:
Time interval <tint>:
Interface Settings are the default factory settings.
Parameter
LAN interface:
USB interface:
DHCP:
Auto IP:
IP Address:
Subnet Mask:
Default Gateway:
DNS Server:
Host Name:
LAN Services:
Telnet prompt:
IP addresses of Windows Internet
Name System
Power must cycled for interface enable or LAN service changes to take effect.
LAN settings changes require a LAN restart.
92
Setting
1.00e-2
4.0
3.0
1.0
3.5
1.00e-3
OFF
5 minutes
1 second
Setting
enabled
enabled
On
On
169.254.4.61
255.255.0.0
0.0.0.0
0.0.0.0
K-2152A-nnnnn (where nnnnn is last 5 digits of
the serial number)
All enabled
"BT2152A> "
0.0.0.0
Keysight BT2152A Operating and Service Guide