Automatic Synchronisation After Power Failure; Automatic Synchronisation At The „Closed" End Point - RADEMACHER RolloSystems T2 Instruction Manual

Automatic synchronisation after power failure

i
Automatic synchronisation at the „Closed" end point
Automatic end point search (synchronisation)
If the end points were set by means of the automatic search run, after a power failure the end
points are automatically searched for again (synchronisation). To do this, the drive carries out up
to four synchronisation runs, depending on circumstances, until the end points have been definitively
located.
NOTE
Deactivating automatic synchronisation.
If the end points have been set manually, automatic synchronisation after a power failure is
deactivated. This means that the end stops may be displaced after a power failure, in which case
the end points have to be reset manually.
What happens if synchronisation has been unsuccessful?
If no end points have been located after the fourth synchronisation run, the drive switches to
„Asynchronous mode".
= Asynchronous mode is shown on the displayand flashes. Correct operation
is then no longer possible.
Repeat synchronisation by transmitting a travel command or repeat end point
settings.
To ensure smooth operation, solid (fixed, immovable) end points must be available for the
drive in both travel directions.
= LED display after successful synchronisation at the „Closed" end point.
If the end points are identified during installation, the drive automatically synchronises at the
„Closed" end point . This ensures that the sliding unit is always completely closed when in a
„Closed" position.
GB
43