Important Notes After Installation; Attach Safety Notices With Warning Messages; Establish Operational Readiness Of The Door; Programming - RADEMACHER RolloPort S2 Translation Of The Original Operating And Assembly Manual

Important notes after installation

◆ After installation, ensure that the mechanism is properly
adjusted and that the drive reverses when the door
contacts a 50 mm high object placed on the floor
(for drives incorporating an entrapment protection
system depending on contact with the bottom edge of
the door), s. page 10.

Attach safety notices with warning messages

Improper use results in an increased risk of
injury.
◆ Before initial operation, attach the enclosed safety
notices to suitable places on your garage door and on
the profile slide.
◆ Attach all notices so that they are clearly legible.

Establish operational readiness of the door

1. Move the door carefully, in order to engage
the profile slide.
2. Plug the mains plug into the socket and
switch on the electricity.
3. The light goes on and the unit gives a single
beep and the display shows '0' at regular
intervals.

Programming

In order that the following settings are cor-
rectly stored and executed, you must carry
out a final programming procedure according
to page 27.
◆ After installation, ensure that the drive prevents or stops
the opening movement when the door is loaded with
a mass of 20 kg, fixed centrally on the bottom edge
of the door. This applies especially to drives which can
be used with a door that has openings in the door leaf
larger than 50 mm in diameter.
EN
21