Functional Description - RADEMACHER RolloSystems T2 Instruction Manual

i

Functional description

GB
The RolloSystems T2 can be used to automate standard sliding doors/sliding shutters. The system
is assembled using the corresponding assembly set.
Simple menu navigation for rapid installation
Simple menu navigation enables the system to be installed rapidly and all major parameters to be
adjusted. With its wide range of setting options, the drive can be adapted to site-specific conditions
and individual requirements.
Installation is also made easier by automated sequences. For example, the end points are auto-
matically learned and saved.
Gentle motion sequences lessen wear and tear
The movement of the sliding door/sliding shutter is initiated with a soft start, and before the end
point is reached the drive switches to soft stop so that the movement ends slowly.
Safety functions
An obstacle detection function monitors the movement of the sliding door/sliding shutter for
malfunctions (see below). Additionally the drive can be manually decoupled should a malfunction
occur (e.g. in the event of power failure).
Power supply
The sliding door drive is operated by means of 24 V safety low voltage, so it is supplied with a
corresponding 24 V power unit which can be plugged into any 230 V / 50 Hz power socket.
Flexible connection options for additional operating units
The RolloSystems T2 has two control inputs and one 12 V output for connecting external sensors,
motion detectors, tread sensors and other pulse sensors.
Definition of terms
For simplicity, the term „sliding unit" will be used in the following chapters instead of „sliding
door/sliding shutter".
9