Reversing The Running Direction - RADEMACHER RolloSystems T2 Instruction Manual

Reversing the running direction

Keys
1.
Press for two
OK
seconds
2.
/
3.
OK
4.
Press for three
OK
seconds
5.
OK
24
The running direction of the sliding unit is dependent on the following factors and may need to
be adjusted:
on the installation situation (right-hand / left-hand installation) and
on the connection of the sliding unit to the toothed belt (front or rear toothed belt).
NOTE
Valid end points have to be learned so that the direction of travel can be checked. Then for every
movement of the door, the direction of travel is shown in the LED display as follows:
Door travel direction
Opening
Closing
IMPORTANT
Repeating end point search and reference runs.
When reversing the running direction, the end points and the reference run settings are automatically
deleted and must be repeated (see page 22/23).
LED display
LED display
= (open)
= Also on the first search run to learn the end points.
= (close)
Call up the menu.
Select function
Confirm selection
The current status of the function is shown and flashes
(e.g. )
= Reversal of running direction is deactivated.
= Reversal of running direction is activated.
Reverse running direction.
Return to menu.
GB
„Running direction".
.