Installing The Disk Drive - Lanner LEC-7230M User Manual

Installing the Disk Drive

The system can accommodate one Serial-ATA disk drive.
Follow these steps to install a hard disk into the system:
1. Locate the disk drive bay on the back side of the top
compartment.
2. Place the disk drive (HDD or SSD) as shown in the
image below.
3. Lock the disk drive from the other side of the cover and
apply four screws.
4. Your SATA disk drive should be placed as the image
below.
5. Connect the SATA cable as shown in the image below.
First, plug the SATA connector of the cable to the disk
drive, then place the 7-pin SATA signal connector and
the 4-pin SATA power connector to the corresponding
connectors on the motherboard.