Chapter 4
Installing the Hard Disk
The system can accommodate one Serial-ATA disk. Follow
these steps to install a hard disk into the system:
1.
Take out the hard disk tray and fix the hard disk on
the tray with 4 mounting screws as illustrated in the
following picture.
2.
Plug the Serial-ATA cable to the hard disk.
3.
Place the hard disk back to the system's chassis and fix
it with the mounting screws.
4.
Connect the Serial-ATA power and data disk cables to
the Serial-ATA power and disk connectors on the main
board respectively.
1
2
4
Embedded and Industrial Computing
3
Wall Mounting
The product ships with wall mounting kit. To mount your
product on the wall, follow the instructions below:
1.
First make a hole for the anchor in the surface on the
wall. Use the following diagram as a guideline for
placing the anchors.
2.
Then press the anchor into the hole until it is flush with
the surface. You may need a hammer to tap the wall
anchor.
3.
Use a screwdriver to screw the threaded screw into the
plastic anchor.
4.
Attach the wall mounting bracket to the back of the
device, securing it in place with four of the flat-head
screws provided.
5.
Hang the device on the wall.
Hardware Setup
20