Installing Disk Drives - Lanner LEC-2580 User Manual

Installing Disk Drives

The system supports 1 x dual 2.5" SATA HDD/SSD drive bay as data storage (SSD is recommended due to heat
and vibration concerns). Please follow the steps below for installation.
1. Locate the dual 2.5" SATA HDD/SSD drive bay at the back of the bottom compartment.
2. Place disk drives onto the drive bay and apply two screws on each side of a SATA disk drive.
3. Connect the SATA 7-pin signal cable and the SATA 4-pin power cable to their corresponding connectors on
the motherboard.
4. Plug the standard 7+15 SATA connector to the SSD.
29