Chapter 4: Hardware Setup; Preparing The Hardware Installation; Installing The System Memory - Lanner LEC-7230M User Manual

Chapter 4:
Hardware Setup

Preparing the Hardware Installation

To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING:
Please remove all the power
connection before conducting the
following hardware installations.
It is strongly recommended to wear ESD
proof gloves for the following setups.
1. Turn LEC-7230M upside-down.
2. Loosen the 4 locking pads circled in the image below
and remove them from the bottom cover.
3. Use the notches on both sides to open the cover.

Installing the System Memory

Please follow the steps for installing the system memory
module.
1. Align the memory module's key with the DIMM
module.
2. Install the DIMM module as shown in the image below.
3. Press the module down until it is clipped in.
Note:
The system can support memory of 204-pin SO-
DIMM 1333MHz DDR3L SDRAM memory up to
8GB. Please install the module compatible with
this specification to ensure proper operations.