Table of Contents
Advertisement
GENERAL SAFETY INSTRUCTIONS
Read and understand the owner's manual and labels affixed to the product. Learn its application
and limitations as well as the specific potential hazards. Retain these instructions for future
reference. The operator is responsible for following the warnings & instructions in this manual and
on the product.
STAY ALERT
Do not operate the machine while under the influence of drugs, alcohol, or any medication that
could affect your ability to use it properly. Do not use this machine when you are tired or distracted
from the job at hand. Be aware of what you are doing at all times. Use common sense.
AVOID DANGEROUS CONDITIONS
Make sure there is adequate surrounding workspace. Cluttered areas invite injuries.
Keep your work area clean with sufficient light. Keep the area around the machine clear of
obstructions, grease, oil, rubbish & other debris which could cause persons to fall onto moving parts.
INSPECT YOUR MACHINE
Check all bolts, nuts & screws for tightness before each use, especially those securing guards & drive
mechanisms. Vibration during use, may cause these to loosen.
Replace damaged, missing or failed parts before using.
Warning labels carry important information. Replace any missing or damaged warning labels.
CRUSH AND CUT HAZARDS
Always keep your hands and feet clear from moving parts while operating the equipment.
Always keep the work area clean and clear when operating.
DRESS PROPERLY
Do not wear loose clothing or jewellery (rings, wrist watches), which can be caught in moving parts.
CONDITIONS
We recommend the machine is not used during winds. This may affect the spreading pattern.
DO NOT OVERREACH
Keep proper footing and balance. Never stand on the machine. Serious injury could occur if the
machine is tipped or if the moving parts are unintentionally contacted. Do not store anything above
or near the machine, where anyone might stand on the machine to reach them.
AVOID INJURY FROM UNEXPECTED ACCIDENT
Keep hands & feet out of the way of all moving parts. Do not place any part of your body or any tool
e.g. in moving parts of the machine during operation.
DO NOT FORCE TOOL
Always work within the rated capacity. Do not operate for a purpose for which it was not intended.
MAINTAIN YOUR MACHINE WITH CARE
Clean the machine immediately after use. Keep the machine clean to ensure it operates to its full &
safest performance. When maintaining this machine, only the manufacturer's original replacement
parts should be used. The use of non-original manufacturer parts may invalidate your warranty.
PROTECT THE ENVIRONMENT
Take left over materials to an authorised collection point or follow the stipulations in the country
where the machine is used. Do not discharge into drains, soil or water.
STORE IDLE EQUIPMENT
When not in use, the machine should be stored in a dry location. Keep the machine away from
children and others not qualified to use it.
OPERATION SPEED
Do not exceed 10mph, to avoid personal injury and/or equipment damage.
TYRE INFLATION
Before operating, make sure the tyres have the recommended pressure of 20 PSI (Do not exceed 20
PSI). We recommend the use of FOOT or HAND inflation devices only. Do not use electric or
mechanical inflation devices. This is a garden/domestic product, therefore extended use over
abrasive surfaces (e.g. concrete, tarmac etc.) could cause premature wear on the tyres.
Advertisement
Table of Contents
