Communication Level - ABB Navigator 540 Instruction Manual

3 Communication level

IMPORTANT (NOTE) Communication level menus are
enabled only if an optional communications module is
fitted and the parameters displayed are specific to the
type of module fitted. For example, if a Modbus module
is fitted, Modbus parameters are enabled, but Ethernet
parameters are neither enabled nor displayed.
The Communication level is accessed from the Advanced
access level. To access the communication level and the
configuration parameters for the communications module
fitted:
1. Press the key (below the
page).
Navigator
Tag 1
2.93
21.7 21.7
Na
The Operator menu is displayed:
Navigator
Operator Pages
4.28 4.28
Data Views
Logs
Alarm Acknowledge
21.7 21.7
Manual Hold
Autoscroll
Media Card
Enter Configuration
2. Press the key to scroll to Enter Configuration and
press the key.
The Access Level page is displayed:
Access Level
Read Only
Calibrate
Advanced
Service
Back
3. Use the key to scroll to Advanced and press the
key (below the Select prompt).
icon on any Operator
10 : 34: 52
2012–04–15
ppb
°C
CAL
10 : 34: 52
2012–04–15
ppb
°C
Select
4. Use the and
level:
Menu
Communication
Exit
key (below the Select prompt).
5. Press the
The Communication page appropriate to the
communication module fitted is displayed:
Communication
PROFIBUS
Back
PROFIBUS – refer to Section 4, page 8.
Communication
MODBUS
Back
MODBUS – refer to Section 5, page 13.
Communication
Ethernet
Back
Ethernet – refer to Section 6, page 15.
Navigator 540 | Transmitter | COM/AWT540/PB–EN Rev. C
keys to scroll to the Communication
Select
Select
Select
Select
7