Health & Safety; Document Symbols; Safety Precautions; Potential Safety Hazards - ABB Navigator 540 Instruction Manual

1 Health & Safety

1.1 Document symbols

Symbols that appear in this document are explained below:
DANGER – Serious damage to health / risk to life
This symbol in conjunction with the signal word
'DANGER' indicates an imminent electrical hazard.
Failure to observe this safety information will result in
death or severe injury.
WARNING – Bodily injury
This symbol in conjunction with the signal word
'WARNING' indicates a potential electrical hazard.
Failure to observe this safety information will result in
death or severe injury.
CAUTION – Minor injuries
This symbol in conjunction with the signal word
'CAUTION' indicates a potentially dangerous situation.
Failure to observe this safety information may result in
minor or moderate injury. The symbol may also be used
for property damage warnings.
NOTICE – Property damage
This symbol indicates a potentially damaging situation.
Failure to observe this safety information may result in
damage to or destruction of the product and / or other
system components.
IMPORTANT (NOTE)
This symbol indicates operator tips, particularly useful
information or important information about the product
or its further uses. The signal word 'IMPORTANT
(NOTE)' does not indicate a dangerous or harmful
situation.
4 COM/AWT540/PB–EN Rev. C | Navigator 540 | Transmitter

1.2 Safety precautions

Be sure to read, understand and follow the instructions
contained within this manual before and during use of the
equipment. Failure to do so could result in bodily harm or
damage to the equipment.
WARNING – Bodily injury Installation, operation,
maintenance and servicing must be performed:
— by suitably trained personnel only
— in accordance with the information provided in this
manual
— in accordance with relevant local regulations

1.3 Potential safety hazards

1.3.1 Navigator AWT540 transmitter – electrical
WARNING – Bodily injury
To ensure safe use when operating this equipment, the
following points must be observed:
— Up to 240 V AC may be present. Be sure to isolate
the supply before removing the terminal cover.
— Normal safety precautions must be taken to avoid
the possibility of an accident occurring when
operating in conditions of high pressure and / or
temperature.
Safety advice concerning the use of the equipment
described in this manual or any relevant Material Safety
Data Sheets (where applicable) can be obtained from
the Company, together with servicing and spares
information.

1.4 Safety standards

This product has been designed to satisfy the requirements of
IEC61010-1:2010 3rd edition 'Safety Requirements for
Electrical Equipment for Measurement, Control and Laboratory
Use' and complies with US NEC 500, NIST and OSHA.