ORiNG DGS-7084GCP-AIO_S SERIES User Manual page 30

DGS-7084GCP-AIO_S SERIES User's Manual
Select any available link speed for the given switch port.
Configured Link Auto Speed selects the highest speed that is compatible with a
Speed link partner.
Disabled disables the switch port operation.
When Auto Speed is selected for a port, this section indicates the
flow control capability that is advertised to the link partner.
When a fixed-speed setting is selected, that is what is used. The
Current Rx column indicates whether pause frames on the port
Flow Control are obeyed, and the Current Tx column indicates whether pause
frames on the port are transmitted. The Rx and Tx settings are
determined by the result of the last Auto-Negotiation.
Check the configured column to use flow control. This setting is
related to the setting for Configured Link Speed.
Enter the maximum frame size allowed for the switch port,
Maximum Frame
including FCS. The allowed range is 1518 bytes to 9600 bytes.
Configure port transmit collision behavior.
Excessive Collision
Discard: Discard frame after 16 collisions (default).
Mode
Restart: Restart back-off algorithm after 16 collisions.
The Usage column shows the current percentage of the power
consumption per port. The Configured column allows for changing
the power savings mode parameters per port.
Power Control Disabled: All power savings mechanisms disabled.
ActiPHY: Link down power savings enabled.
PerfectReach: Link up power savings enabled.
Enabled: Both link up and link down power savings enabled.
Total Power Usage Total power usage in board, measured in percent.
Click to save changes.
Click to undo any changes made locally and revert to previously
saved values.
Click to refresh the page. Any changes made locally will be
undone.
ORing Industrial Networking Corp 29