ORiNG DGS-7084GCP-AIO_S SERIES User Manual page 100

Industrial managed gigabit bypass ethernet switch
Table of Contents

Advertisement

Port State
Max Clients
ORing Industrial Networking Corp
DGS-7084GCP-AIO_S SERIES User's Manual
802.1X-aware will be denied access.
Authorized: Forces the port to grant access to all clients,
802.1X-aware or not. The switch transmits an EAPOL Success
frame when the port links up.
Unauthorized: Forces the port to deny access to all clients,
802.1X-aware or not. The switch transmits an EAPOL Failure
frame when the port links up.
MAC-Based: Enables MAC-based authentication on the port.
The switch doesn't transmit or accept EAPOL frames on the port.
Flooded frames and broadcast traffic will be transmitted on the
port, whether or not clients are authenticated on the port, whereas
unicast traffic against an unsuccessfully authenticated client will
be dropped. Clients that are not (yet) successfully authenticated
will not be allowed to transmit frames of any kind.
The current state of the port. It can undertake one of the following
values:
Disabled: 802.1X and MAC-based authentication is globally
disabled.
Link Down: 802.1X or MAC-based authentication is enabled, but
there is no link on the port.
Authorized: The port is authorized. This is the case when 802.1X
authentication is enabled, the port has link, and the Admin State is
"Auto" and the supplicant is authenticated or the Admin State is
"Authorized".
Unauthorized: The port is unauthorized. This is the case when
802.1X authentication is enabled, the port has link, and the Admin
State is "Auto", but the supplicant is not (yet) authenticated or the
Admin State is "Unauthorized".
X Auth/Y Unauth: X clients are currently authorized and Y are
unauthorized. This state is shown when 802.1X and MAC-based
authentication is globally enabled and the Admin State is set to
"MAC-Based".
This setting applies to ports running MAC-based authentication,
only.
The maximum number of clients allowed on a given port can be
configured through the list-box and edit-control for this setting.
Choosing the value "All" from the list-box allows the port to
99

Advertisement

Table of Contents
loading

Table of Contents