Grounding The Unit; I/O Channel Jumper Setting - Moxa Technologies ioLogik E1211 User Manual

ioLogik E1200 Series

Grounding the Unit

I/O Channel Jumper Setting

The following table shows jumper setting for each model of the ioLogik E1200 Series. We provide a more
detailed description of three different jumper settings.
Model
E1212
E1213
E1240
E1242
STEP 3. At this point, if the mounting was done correctly, the unit should be
securely fixed to the wall.
Top View
Jumper Setting
DIO direction (DI, DO)
1. DIO direction (DI, DO)
2. EXT Power Configuration
AI mode (Voltage, Current)
1. DIO direction (DI, DO)
2. AI mode (Voltage, Current)
STEP 2. Use screws to fix the unit to the wall, as shown in the
diagram. Reserve at least 1.5 cm of space above and below
the unit to ensure that the installation can be done correctly.
The ioLogik E1200 has a grounding point located on the top
panel of the terminal block. Connect the ground pin ( ) to earth
ground.
Item
Wire range
Screw Torque
2-4
Initial Setup
Suggested Setting
12 to 24 AWG
7 lb-inch