Labrie MINIMAX Maintenance Manual page 68

60 Lubrication
Figure 4-3 Probe cap and tip
Install the probe on the coupler to fill the sample bottle. Use an EMA coupler with M16 × 2.0
3.
threads.
Fill the bottle to the level mark (the pump must be engaged to do this). Remove excess oil
4.
through the vent. D
Figure 4-4 Recommended oil level
Once the sample is taken, remove the probe from the coupler and pull out the probe to remove it
5.
from the bottle (see Figure 4-5).
Figure 4-5 Pulling out the probe from the bottle
Cap
!
O NOT OPEN THE BOTTLE
Tip