Labrie MINIMAX Maintenance Manual page 59

Figure 3-33 Arm stowed limit switch
This limit switch is located behind the left gripper finger when facing the arm.
To adjust the arm stowed limit switch:
Park the vehicle on safe and level ground.
1.
Fully open the gripper and retract the arm alongside the body.
2.
Adjust the limit switch in such a way that the A
3.
stop flashing when the gripper is fully open and the arm is fully retracted. To do this:
Loosen limit switch nut.
3 a.
Adjust the rod (see Figure 3-34) so that the gripper finger will trigger the limit switch (click
3 b.
sound) and turn off the warning light.
Figure 3-34 Limit switch rod
Tighten back up nut.
3 c.
Slightly close the gripper or extend the arm out (about 1 inch). The A
4.
light should start flashing.
E warning light on the dashboard
RM XTENDED
RM
General Maintenance 51
E warning
XTENDED