Labrie MINIMAX Maintenance Manual page 49

Fully retract the packer and press the green P
15.
efficiency of the limit switch.
: Repeat this procedure until you achieve the proper settings for the limit switch.
N
OTE
B. To adjust the packer extend proximity switch:
Set the parking brake.
1.
Turn on the engine and the hydraulic system (P
2.
Usually, the packer extend proximity switch needs adjustment when the last follower panel
moves past the switch without triggering any signal. In such a case, the packer continues its
forward motion inside the body as in Eject mode.
Press and hold the Auto-Eject switch on the multiplexed control module (see Figure 3-17). Keep
3.
this switch down until the tailgate is fully open and the last follower panel clears the proximity
switch in the hopper.
As soon as you release the Auto-Eject switch, the packer will stop moving.
Caution! Make sure no one is standing behind the truck when you operate the tailgate.
Turn off the engine.
4.
Proceed with the tagout/lockout procedure. Refer to "Locking Out and Tagging Out the
5.
Vehicle" on page 20.
Never get on the hopper area while the engine is running.
Danger!
Get on the hopper area.
6.
Free the proximity switch from any dirt or debris that may cause the switch to malfunction.
7.
Turn on the engine and the hydraulic system (P
8.
Caution
Make sure the ball valve on the suction line is fully open before starting the vehicle.
Press the yellow P
9.
back to the position where the target, which is located at the tail of the last follower panel, must
make contact with the Packer Extend proximity switch. Use the red E
stop retraction at such position (see Figure 3-10).
R button (see Figure 3-13) to retract the packer and bring it
ACKER ETRACT
button to start a complete cycle and test the
ACK
switch activated).
UMP
switch activated).
UMP
MERGENCY
General Maintenance 41
S button to
TOP