Labrie MINIMAX Maintenance Manual page 144

136 Multiplexing
Table 2 Error messages (cont'd)
Should the system issue a warning or a caution message, it will appear on the same page as the cart
counter.
For example, if the following caution message "Pump Not Started: Main Air Pressure" is issued by the
system, it will appear on the Cart Counter page of the display monitor. An action that could be taken
by the operator, when faced with such a situation, would be to wait until the required main air
pressure level is reached.
For a specific problem or condition that requires special attention, the multiplexed system can alert
the operator to a possible cause, which appears in bold and in large print on the monitor screen
(active cause). The operator should check if the problem stems from the highlighted or active cause.
One possible cause is highlighted at a time. What is shown in light and small print in the lower part of
the screen are causes that have already been dealt with (see Figure 9-5).
Error Messages
CAN Error Level 3
Comm. Lost with Master
Module 11 is disconnected
Module 11 not Connected
Module 20 is disconnected
Module 20 not Connected
Module 30 is disconnected
Module 30 not Connected
Module 50 is disconnected
Module 50 not Connected
Module 60 is disconnected
Module 60 not Connected
Solution
Refer to LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus