Labrie MINIMAX Maintenance Manual page 53

Figure 3-26 Tailgate proximity switch (unlocked position)
To adjust the tailgate unlocked proximity switch:
Start the engine and engage the hydraulic system.
1.
Loosen the nuts located on each side of the proximity switch bracket (see Figure 3-27).
2.
: The second nut is on the hidden side of the body wall.
N
OTE
Figure 3-27 Tailgate proximity switch
Adjust the proximity switch so that the switch can be triggered by the plate as the cylinder head
3.
moves down. There should be a gap of approximately 3/16 of an inch between the plate and the
switch.
Tighten up both nuts.
4.
Open the tailgate a little using the T
5.
(see Figure 3-7), and listen if the warning buzzer and backup alarm start to sound as the tailgate
unlocks.
Repeat the procedure if need be.
6.
Proximity
switch
Proximity
switch
AILGATE
Plate
Plate
Nut
U switch on the multiplexed control module
P
General Maintenance 45