Labrie MINIMAX Maintenance Manual page 48

40 General Maintenance
Proceed with the tagout/lockout procedure. Refer to "Locking Out and Tagging Out the
5.
Vehicle" on page 20.
Never get on the hopper area while the engine is running.
Danger!
Get on the hopper area.
6.
Free the limit switch from any dirt or debris that may cause the switch to malfunction.
7.
Turn on the engine and the hydraulic system (P
8.
Caution Make sure the ball valve on the suction line is fully open before starting the vehicle.
Press the yellow P
9.
back to the position where the target, which is located at the tail of the last follower panel, must
make contact with the Packer Extend limit switch lever. Use the red E
stop retraction at such position (see Figure 3-10).
Turn off the engine.
10.
Proceed with the tagout/lockout procedure. Refer to "Locking Out and Tagging Out the
11.
Vehicle" on page 20.
Never get on the hopper area while the engine is running.
Danger!
Use an Allen key to loosen the locknut on the limit switch and determine the contact point where
12.
the triggering should occur by moving the lever.
Once you have determined the contact point where the triggering should occur, tighten back the
13.
locknut.
Turn on the engine and engage the hydraulic system (P
14.
Caution
Make sure the ball valve on the suction line is fully open before starting the vehicle.
R button (see Figure 3-13) to retract the packer and bring it
ACKER ETRACT
switch activated).
UMP
MERGENCY
switch activated).
UMP
S button to
TOP