Labrie MINIMAX Maintenance Manual page 61

Open the black plastic spring equipped retracting cover that is on top of the arm base (see Figure
5.
3-37).
Use a stepladder for easy access to that part of the arm.
Unscrew the lever screws of the limit switch (see Figure 3-38).
6.
Raise or lower the detection lever a little bit and tighten up the screws (see Figure 3-38).
7.
The detection lever or actuator must touch the black curved plastic cover when the arm is in the
hopper for the switch to be triggered.
Warning Injury or death may occur if you attempt to enter the body while the packer or arm is in
operation.
Close the black plastic springed cover.
8.
Start the engine and engage the hydraulic pump.
9.
Caution
Make sure the ball valve on the suction line is fully open before starting the vehicle.
Test the operation.
10.
Repeat the procedure until the limit switch is properly adjusted. The A
11.
light should turn off when the arm is in parked travel position (see Figure 3-35).
Figure 3-36 Arm parked limit switch
General Maintenance 53
E warning
RM XTENDED