Labrie MINIMAX Maintenance Manual page 41

To reinstall the packer, proceed this way:
Make sure the tailgate is properly open, and all packer components are properly assembled.
1.
Proceed with the tagout/lockout procedure. Refer to "Locking Out and Tagging Out the
2.
Vehicle" on page 20.
Use a safe lifting device and hook the packer by the ring handle (see Figure 3-12).
3.
Lift the packer and align it with the side rails inside the body.
4.
Insert the wear plate panels in the rails and push the packer in.
5.
On the packer control station, press the green P
6.
packer cylinder.
Slowly extend the cylinder in order to properly align it with the packer and to avoid impact
Warning!
that could cause damage to the equipment.
Insert the cylinder into the packer, then the pin through the tip of the packer and into the cylinder
7.
to fix them properly.
Turn on the engine and the hydraulic system (P
8.
Caution
Make sure the ball valve on the suction line is fully open before starting the vehicle.
On the packer control station, press the yellow P
9.
its home position (see Figure 3-16).
Figure 3-16 Packer retract button
Extend and retract the packer in E
10.
properly installed.
To activate this mode, press and hold the A
(see Figure 3-17).
button (see Figure 3-8) to fully extend the
ACK
switch set to "ON").
UMP
R
ACKER ETRACT
mode for a full cycle to make sure the packer has been
JECT
-E switch on the multiplexed control module
UTO JECT
General Maintenance 33
button to retract the packer to