Multi-Function Input 2 Parameters - Curtis enAble 40 Manual

PARAMETER
Off / Seat
Active Low
Charger inhibit
Halt Act 1 Dir-
Halt Act 1 Dir+
Halt Act 2 Dir-
Halt Act 2 Dir+
Speed Limit
Curtis enAble 40 Manual,
®
5 — PROGRAMMABLE PARAMETERS:
Multi-Function Input 2
to set a corresponding speed limit. Multi-Function Input 2 is at Pin 6 on the
14-pin connector; see Figure 6, page 9.
MULTI-FUNCTION INPUT 2 MENU
RANGE
0–1 0 = Multi-Function Input 2 ignored.
1 = Inhibit and/or Speed Limit functions active, depending on whether
input is high or low (see next parameter).
On/Off When programmed On, the Inhibit and Speed Limit functions are
active when the switch is closed (pulled low to B-); when programmed
Off, these functions are active when the switch is open.
On/Off Enables Input 2 to be used with an on-board charger. The charger will
pull the inhibit active during charging, which will inhibit drive, light the
charger and battery icons in the handcontrol display, and engage the
EM brake.
On/Off Actuator 1 will be halted in the negative direction.
On/Off Actuator 1 will be halted in the positive direction.
On/Off Actuator 2 will be halted in the negative direction.
On/Off Actuator 2 will be halted in the positive direction.
0–100 % Sets the speed limit that will be in effect when Input 2 is active.
Rev. E
menu can be used to inhibit one or both actuators, and
DESCRIPTION

Multi-Function Input 2 Parameters

31