Curtis enAble 40 Manual page 20

3 — USER HANDCONTROL
Fig. 8c Keypad for
the Drive + Actuators
handcontrol.
14
Drive with Actuators (6-button keypad)
This keypad's six buttons are the standard four (On/Off, Horn, Speed Up,
Speed Down) plus two buttons to activate the two actuator modes. The mode
buttons show one dot (for Mode 1) and two dots (for Mode 2).
Actuator Mode Buttons
With this handcontrol, there's a button for each mode: Actuator Mode 1 and
Actuator Mode 2. The joystick must be in neutral before pressing an actuator
mode button. Pressing both Mode buttons simultaneously causes both actuators
to be active (assuming Simultaneous Mode is programmed On). If Actuator
Mode 1 is programmed Off (=0), either button will select Actuator Mode 2.
The fill-in portions of the LCD's chair icon illuminate to indicate the active
actuator(s). In this example, Actuator Mode 1 is the seatback, Actuator Mode 2 is
the seat, and Simultaneous Mode is programmed On. See Seat menu, page 28.
MODE 1
BUTTON ( )
PRESSED
Once in actuator mode via one of the mode buttons, repeatedly moving the
joystick to the right will cycle through the available actuator options. To exit
actuator mode, either move the joystick to the left or press the button corre-
sponding to the active mode again.
MODE 1
BUTTON ( )
PRESSED
MODE 2 BOTH
BUTTON ( ) MODE BUTTONS
PRESSED PRESSED
MODE 2 MODE 1 AND MODE 2
BUTTON ( ) BUTTONS ( + )
PRESSED PRESSED
Curtis enAble 40 Manual,
®
Rev. E