Drive Parameters (Profiles 1&2); Drive - Curtis enAble 40 Manual

PARAMETER
Fwd Max Speed
Fwd Min Speed
Fwd Accel High Speed
Fwd Accel Low Speed
Soft Start
Fwd Decel High Speed
Fwd Decel Mid Speed
Fwd Decel Low Speed
Soft Stop
Rev Max Speed
Rev Min Speed
Rev Accel High Speed
Rev Accel Low Speed
Rev Decel High Speed
Rev Decel Low Speed
Tremor Suppression
Quick Stop Factor
Emergency Stop
Curtis enAble 40 Manual,
®
5 — PROGRAMMABLE PARAMETERS:
The menu contains the major parameters that affect the forward and

Drive

reverse speed, response, and feel of the chair. There are separate Drive menus
for Profile 1 and Profile 2.
DRIVE MENU
RANGE
1–100 % Full forward speed when speed limit is 100%.
1–100 % Full forward speed when speed limit is 0%.
1–100 % Forward acceleration when speed limit is 100%.
1–100 % Forward acceleration when speed limit is 0%.
0–100 % Higher values make the drive take-off smoother.
1–100 % Deceleration rate used when chair is traveling forward at high speed.
1–100 % Deceleration rate used when chair is traveling forward at medium speed.
1–100 % Deceleration rate used when chair is traveling forward slowly.
1–100 % Deceleration rate used just before the chair stops. Lower values
make the stop smoother.
1–100 % Full reverse speed when speed limit is 100%.
1–100 % Full reverse speed when speed limit is 0%.
1–100 % Reverse acceleration when speed limit is 100%.
1–100 % Reverse acceleration when speed limit is 0%.
1–100 % Deceleration rate used when chair is traveling at high speed in reverse.
1–100 % Deceleration rate used when chair is traveling slowly in reverse.
0–100 % Higher values provide more filtering to suppress rapid hand
movements.
0–100 % Multiplier for the deceleration rate, when the joystick is quickly
reversed from forward. A setting of 50 provides deceleration that
is approximately twice as fast as the normal decel rate. A setting
of 0 provides deceleration at the normal rate, and a setting of 100
provides the fastest possible stop.
1–100 % Deceleration rate applied at key-off or in the event of a fault.
Rev. E
Drive Parameters (for Profiles 1&2)
DESCRIPTION
21