Curtis enAble 40 Manual page 21

Fig. 8d Keypad for the
Drive + Actuators + Lights
handcontrol.
M
Curtis enAble 40 Manual,
®
Drive with Actuators and Lights (8-button Keypad)
This keypad's eight buttons are the standard four (On/Off, Horn, Speed Up,
Speed Down) plus a Running Lights button, two buttons for the turn indica-
tors (left and right), and an Actuator Mode button.
The hazard lights (i.e., flashing left and right turn signals, front and rear)
are activated by pressing both turn indicator buttons simultaneously. They will
continue to flash even if the system is powered down. To turn off the hazard
lights, press either indicator button again.
Mode Button
With the chair in Drive and the joystick in neutral, pressing the Mode button
selects Actuator Mode 1; if Actuator Mode 1 is programmed Off (=0), the ini-
tial press of the Mode button selects Actuator Mode 2. Repeatedly moving the
joystick to the right will cycle through the available actuator options. To exit
actuator mode, press the Mode button again or move the joystick to the left.
The fill-in portions of the LCD's chair icon illuminate to indicate the active
actuator(s). In this example, Actuator Mode 1 is the seatback, Actuator Mode 2 is
both legs, and Simultaneous Mode is programmed On. See Seat menu, page 28.
MODE BUTTON
PRESSED
(MODE 1)
Rev. E
M
JOYSTICK MOVED
TO RIGHT
M
(MODE 2)
3 — USER HANDCONTROL
JOYSTICK MOVED
TO RIGHT AGAIN
(MODES 1+ 2)
15