Specifications - AT&T PARTNER Plus Installation And Programming Manual

Specifications

Table 1-1 Technical and Environmental Specifications
Capacities
System
Dimensions
Weights
(approx.)
Switch Fabric
Electrical
Specifications
Extension Jack
Specifications
Environmental
Requirements—
Control Unit
*The two devices combined on an extension jack can be a PARTNER phone with a standard device, or two standard devices; DO NOT connect
two PARTNER phones to the same extension jack. If a device lists two RENs, use the higher number when adding up RENs.
1-4 System Components and Specifications
8 outside lines via line jacks on
four 206 modules
24 extensions via extension jacks
on four 206 modules
1 loudspeaker paging system via
PAGE jack on processor module
1 audio source via MUSIC ON
HOLD jack on processor module
2 doorphones, using 2 extension
jacks
Processor/206 modules
Control unit
PARTNER telephones
Processor module
206 module
Backplane & cover
MLS-6 telephone
MLS-12 telephone
MLS-12D telephone
Full digital, nonblocking
2 amps at full system capacity
200 watts at full system capacity
4-day memory backup (96 hours)
Dissipation of power (65 watts during normal operation)
684 BTUs/hour at peak; 225 BTUs/hr at normal
Ringing voltage: +5VDC, -140 VDC peak to peak; Trapezoidal wave shaping
48-volt talk battery
Ringing frequency: 20 Hz
Mount on a wall or sturdy, level surface at least 2 feet (.6 meters) from the floor (wall mount-
ing strongly recommended)
Locate within 5 feet (1.5 meters) of an electrical outlet not controlled by a switch and within
5 feet (1.5 meters) of the network interface jacks, when using supplied 7
Operating temperature 32° to +I04°F (0° to +40
Humidity 15%-90%, noncondensing
For proper ventilation and easy replacement of modules, provide at least 6" (2.34cm) clear-
ance at the top and sides and 1 foot (0.3 meters) at the front of the control unit.
Locate in an area
free of excess moisture, corrosive gases, dust, and chemicals
206 Module
2 outside lines
6 extensions
11"(D) x 17"(H) x 1.5"(W)
or
12"(D) x 19"(H) x 11"(W)
9.5"(D) x 5"(H) x 6.75"(W) or 3.7cm x 1.9cm x 2.6cm (assembled)
4.0 lbs or 8.8 kgs
4.5 Ibs or 9.9 kgs
5.5 Ibs or 12.2 kgs
1.8 lbs or 4.0 kgs
2.0 Ibs or 4.4 kgs
2.1 Ibs or 4.6 kgs
o
C), not in direct sunlight
Extension Jack
Maximum 2 devices per exten-
sion jack, total REN on jack not
to exceed 2* (2 devices require
AT&T 267F2 bridging adapter)
No more than one PARTNER
phone per jack.
A PARTNER display
phone must be connected
to Extension 10.
or 4.3cm x 6.6cm x .58cm
4.7cm x 6.8cm x 4.3cm (assembled)
-
(2.1-meter) cords