System Password - AT&T PARTNER Plus Installation And Programming Manual

Hide thumbs Also See for PARTNER Plus:
Table of Contents

Advertisement

Toll Call Prefix

System Password

Entering the password allows you
to override several dialing restric-
tions. See appendix B for a sum-
mary of dialing restrictions.
#402
Code:
Description: Phone companies recognize long distance calls in either of two
a telephone number preceded by 0 or 1 plus an area code or a tele-
ways:
phone number preceded only by an area code. Use this procedure to tell the
PARTNER Plus system which method your phone company uses.
Valid Entries:
1 = 0 or 1 plus the area code
2 = Area code only (0 or 1 not necessary)
Programming Steps:
. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 4 ] [ 0 ] [ 3 ]. The
1
display reads:
Toll Call Prefix
1 0/1 + AreaCd
2. To change the toll call prefix, press [ Next Data ] until the appropriate setting
appears. For example,
Toll Call Prefix
2 Area Code Only
Code: #403
Description: Identifies the 4-digit password that lets a user override Outgoing
Call Restrictions (#401). You can also use the password with Night Service
(#503 and #504) to restrict after-hours dialing.
Valid Entries:
Any 4 digits
Considerations: If you assign a password using this procedure, you must enter
the password when-turning Night Service (#503) on or off.
Programming Steps:
1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 4 ] [ 0 ] [ 3 ]. The
display reads:
Set Password
Data----
If a password has previously been set, it will appear on the display.
2. Enter or change the password using the dial pad. For example, to set the
password to 5747, press [ 5 ] [ 7 ] [ 4 ] [ 7 ] . The display reads:
Set Password
Data5747
To remove a password, press [ Remove ]
= Factory Setting
To go to the next procedure: [ Next Proc ]
To go to the previous procedure: [ Prev Proc ]
To return data to the factory setting: [ Remove ]
Togo to a specific procedure: [ # ] [ x ] [ x ] [ x ]
(where XXX is the procedure number)
To exit system programming: [ Feature ] [ 0 ] [ 0 ]
System Programming 3-19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents