AT&T PARTNER Plus Installation And Programming Manual page 34

Hide thumbs Also See for PARTNER Plus:
Table of Contents

Advertisement

Line Use
Restriction
Restricting the use of a line is the
most extreme way to restrict dial-
ing on the PARTNER Plus sys-
tem. For example, an extension
with a the set to "in only" or "no
access," cannot select the line to
dial out, even emergency
numbers. There are other, less
extreme ways to restrict dialing.
See appendix B for a summary of
dialing restrictions.
#302
Code:
Description: Use this procedure to restrict extensions from receiving and/or
making outside calls on specific lines. Since you program line use restrictions
for each line at each extension, you can restrict some lines on an extension
while not restricting others.
Valid Entries:
No restriction (all calls permitted on that line)
1 =
2 =
Out only (can only make outside calls, not receive them,
3 =
In only (can only receive calls, not make them, on that
4 =
No access (the line appears on the phone but cannot
Programming Steps:
1. Press [ Feature ]
0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 3 ] [ 0 ] [ 2 ]. The
[
display reads:
Restrict
Extension:
2. Enter the extension to be programmed. For example, to program exten-
sion 23, press [ 2 ] [ 3 ]. The display reads:
Restrict 23
Line:
3. Enter the line number to be restricted at this extension. For example, to
restrict line 2, press [ 2 ]. The display reads:
Restrict 23 L2
1 No Restriction
4. To change the line restriction
ting number listed above. For example, to restrict the line to incoming
calls, press [ 3 ]. The display reads:
Restrict 23 L3
3 In Only
To restrict another line at this extension, press [ Next Item ] or [ Prev Item ] until the line number
shows on the display. Repeat step
To restrict another extension, press [ Next Proc ] [ Prev Proc ] (or [ # ] [ 3 ] [ 0 ] [ 2 ] , and begin at
step 2.
= Factory Settinq
To go to the next procedure: [ Next Proc ]
Togo to the previous procedure: [ Prev Proc ]
To return data to the factory setting: [ Remove ]
on that line)
line)
receive or make calls; can receive transferred calls)
for this extension, enter the appropriate set-
4.
To go to a specific procedure: [ # ] [ x ] [ x ] [ x ]
(where XXX is the procedure number)
To exit system programming: [ Feature ] [ 0 ] [ 0 ]
System Programming 3-13

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PARTNER Plus and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents