Disallowed Phone Number Lists - AT&T PARTNER Plus Installation And Programming Manual

Disallowed
Phone Number
Lists
See appendix B for a summary of
dialing restrictions.
3-20 System Programming
Code:
#404
Description: Specifies telephone numbers that users cannot dial. For example,
you may want to prevent calls to a specific telephone number or to categories of
numbers such as calls to 976 numbers. Use this procedure to create up to four
lists of up to 10 telephone numbers each. Then use procedure #405,
Disallowed List Assignment, to assign the lists to specific extensions.
Valid Entries: List numbers 1 to 4
Maximum 10 telephone numbers per list
Maximum 12 digits per telephone number
Wildcard character (!) to match any single digit
Programming Steps:
1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 4 ] [ 0 ] [ 4 ]. The
display reads:
DisallowLst
List No:
2. Enter the list to be set up (1 through 4). For example, to select list 1, press
[ 1 ]. The display reads:
DisallowLst
Entry:
3. Select a list entry (01 through 10). For example, to select entry 01, press
[ 0 ] [ 1 ] . The display reads:
DisallowLst
Data ------------
4. Enter the first telephone number, following the guidelines given in the
"Programming Notes" on the following page. As an example, to prevent
local 976 dialing, press [ 9 ] [ 7 ] [ 6 ] . The display reads:
DisallowLst 1 01
Data 976
5. To save the telephone number in memory, press [ Enter ].
To enter other phone numbers in this list, press [ Next Item ] and repeat steps 4 and 5.
To change a phone number, press [ Remove ] and repeat steps 4 and 5.
To delete a phone number, press [ Remove ].
To create another list, press [ # ] [ 4 ] [ 0 ] [ 4 ] and start at step 2 above.
= Factory Setting
To go to the next procedure: [ Next Proc ]
To go to the previous procedure: [ Prev Proc ]
To return data to the factory setting: [ Remove ]
1
1 01
To go to a specific procedure: [ # ] [ x ] [ x ] [ x ]
(where XXX is the procedure number)
To exit system programming: [ Feature ] [ 0 ] [ 0 ]