AT&T PARTNER Plus Installation And Programming Manual page 67

Recall
If users have problems with the
recall signal, you may need to
reset the Recall Timer Duration
(#l07).
Save Number Redial
Unlike Last Number Redial
(p. 4-9), this feature lets the user
make other calls before redialing
the saved number.
A phone can have more .Than one
Save Number Redial button.
4-8 Centralized Telephone Programming
Feature Code: 03
Description: Sends a timed switchhook flash over the telephone line. The user
may need to send a recall signal to use certain Centrex or PBX features, such
as Call Waiting. By programming this feature on a button, the user can send a
recall signal with one touch.
Programming Steps:
1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ Central Tel Prog ]. The
display reads:
CENTRAL TEL PROG
Extension:
2. Enter the extension to be programmed. For example, to program exten-
sion 19, press [ 1 ] [ 9 ]. The dispIay reads:
PROGRAM EXT 19
3. Select a button to program by pressing any programmable button.
4. Press [ Feature ] [ 0 ] [ 3 ]. The display reads:
Recall
To program another feature on this extension, go to step 3 for that feature.
Feature Code: 04
Description: Saves an outside phone number into temporary memory for later
redialing. The number stays in the memory until the user saves a new number.
By programming this feature on a button, the user can save the number with
one touch and later dial it with one touch. System Speed Dial numbers cannot
be saved.
Programming Steps:
1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ Central Tel Prog ]. The
display reads:
CENTRAL TEL PROG
Extension:
2. Enter the extension to be programmed. For example, to program exten-
sion 21, press [ 2 ] [ 1 ]. The display reads:
PROGRAM EXT 21
3. Select a button to program by pressing any programmable button.
4. Press [ Feature ] [ 0 ] [ 3 ] . The display reads:
SaveNumberRedial
To program another feature on this extension, go to step 3 for that feature.