Table of Contents
Advertisement
• CH1/CH2
• CH3/CH4
• CH1
• CH2
• CH3
• CH4
Note
The Audio Channel settings that can be selected are
restricted according to the Streaming Format
setting.
Destination Address
Enter the address of the destination server for
streaming data.
Destination Port
Enter the port number of the destination
server used for streaming.
Reset
Reset the settings of Destination Settings to
the defaults.
3
When finished, select Set to apply the
settings.
Always select Set after changing the settings.
The settings are not applied if Set is not
selected.
4
Select Streaming >Destination Select in
the Network menu, and then select the
destination settings (Destination
Settings1, Destination Settings2,
Destination Settings3) specified in steps
1 to 3.
Starting streaming
1
Connect the camcorder to the Internet
or local network as described in
"Connecting to the Internet" (page 59)
or "Connecting to Other Devices via
LAN" (page 54).
2
Set Streaming >Setting in the Network
menu to On.
Streaming starts according to the settings.
You can also start streaming by assigning the
Streaming function to an assignable button
(page 40) and pressing the button.
Notes
• Streaming cannot be started under the following menu
settings.
When Network Client Mode >Setting in the
Network menu is set to On
When Rec Format >Codec in the System menu is
set to DVCAM(MXF)
When S&Q Motion >Setting in the Recording
menu is set to On
When Interval Rec >Setting in the Recording menu
is set to On
When Simul Rec >Setting in the Recording menu is
set to On
• It may take several tens of seconds to stream actual
video or audio after starting streaming.
• If the streaming transmission destination setting is
invalid or the camcorder does not connect to the
network, "×" appears on the screen as the streaming
status indicator.
• Audio/video data is transmitted as-is via the Internet.
Accordingly, the data may be disclosed to other
parties. Check that the streaming data is being received
by the receiving device. Data may be transmitted to a
third party if the address or other settings are
configured incorrectly.
• Not all frames may be played, depending on the status
of the network.
• The picture quality may deteriorate in scenes with
excessive motion.
• Not all frames may be played when the stream is set to
a large size with a small bit rate. To reduce this, select
a smaller size format for the Streaming Format setting.
• Starting streaming while monitoring will stop the
monitoring.
• File transfer is not supported during streaming. File
transfer is supported after stopping streaming.
• If streaming is started during file transfer, the file
transfer stops. File transfer restarts after stopping
streaming.
• During streaming, the screen information update
frequency is reduced, but this does not affect
operation.
Stopping streaming
Set Streaming >Setting in the Network
menu to Off.
Streaming stops.
You can also stop streaming by pressing an
assignable button assigned with the Streaming
function.
65
Advertisement
Table of Contents
