Table of Contents
Advertisement
5
Position the flange focal length
adjustment chart or other high contrast
object approximately 3 meters (10 ft)
away from the camcorder, and arrange
the lighting to obtain a satisfactory
video output.
Place the subject so that it appears at the
center of the screen at the telephoto end.
Also, make sure that no nearby object closer
to the camera than the chart enters the screen
at the wide-angle end.
6
Set the zoom to the telephoto end, and
align the center of the flange focal
length adjustment chart or other
subject with the center marker on the
screen.
7
Set Rec Format (page 118) >Video
Format to 3840×2160P and Frequency
to 59.94 or 50 in the System menu
8
Set the zoom to the wide angle end, turn
Full Auto mode off, and set the shutter
speed, gain, and iris to the following
settings (page 31).
Shutter speed: Auto shutter
Gain: 0dB
Iris: F1.9 (open)
9
Adjust the lighting and ND filter to an
appropriate brightness.
10
Set the ZOOM switch on the bottom of
the camcorder to SERVO (power zoom
mode).
11
Select Auto FB Adjust >Execute in the
Camera menu.
The flange focal length auto adjustment
starts.
A progress message appears on the screen
during adjustment.
After successful adjustment, a completion
message appears.
Note
• Do not change the ND filter while Auto FB Adjust
execution is in progress.
If you press the CANCEL button during
adjustment
Automatic adjustment of the flange focal length is
aborted and the condition before starting the
adjustment is restored.
If the flange focal length adjustment is not
successful
An error message appears.
Check the subject and lighting conditions, and
repeat the adjustment.
Saving and loading configuration
data
You can save setup menu settings in the
camcorder internal memory or on SD cards and
"Memory Stick" media. This allows you to
quickly recall an appropriate set of menu settings
for the current situation.
Configuration data is saved in the following
categories.
User files
User files save the setting items and data of the
customizable User menu.
You can save up to 64 files on an SD card or
"Memory Stick" media.
By loading this file into the camcorder memory,
you can customize the setup of the User menu.
ALL (all settings) files
ALL files save the configuration data of all
menus. You can save up to 64 files on an SD card
or "Memory Stick" media.
Note
• Device specific data (shading, output levels, and other
data that requires adjustment for the specific device) is
not saved.
Scene files
Scene files save settings for paint items
configured for scenes. You can save up to 5 files
in the internal memory of the camcorder, and up
to 64 files on an SD card or "Memory Stick"
media.
Media supported for saving configuration
data
SDXC memory cards* (Speed Class: 4 to 10,
non-UHS / Capacity: 2 to 32 GB, 64 GB and
larger)
46
Advertisement
Table of Contents
